Centroid Community CNC Support Forum

I would like to see a a manual chamfering or “dual jog” function for lathe. I’ve used a bridgeport Ezpath lathe that had this function and it was very handy. Basically you handwheel to a position to start a chamfer, select 1 of 4 directions for the chamfer then when the function is active moving one ...

I knew it had to be something simple I was missing! Thanks!

As the subject states, Z homes fine, Y homes fine then X trips the home switch and keeps going till the limit stops it.
I did a clean install of windows 10 on my cnc pc and updated CNC12 from 5.08 to 5.30 while I was at it. Re-entered the wizard settings and copied in my previously working cncm.hom ...

The board still works, just the outputs are nonfunctional, I'll get the system ID. Thanks

Guess its cheaper than a new one, especially after the price increase. Is the board serial# the label/barcode on the DB25?

So I accidentally connected +24VDC to EN2 and smoke came out while doing the bench test.... :oops: Now none of the screw terminal outputs work and all the relays on the relay card are stuck in the on (green) state. Activating a relay output just makes the green led dim a bit.
The heartbeat ...

CNCSNW,
That is true of these drives, I'm operating with option #3 right now and relying on the drive enable to stop the drive in the e-stop state. Not ideal I know.

Got it, I'll check those things out. Thanks.

I am setting up and OAK board with Yaskawa SGDA-04AS drives and I have hit a roadblock with the error "412 MPG1 Encoder error" "412 encoder differential error". Can someone clarify the meaning of these faults? I have searched but haven't found much info on it, at least info that narrows down my ...