So I accidentally connected +24VDC to EN2 and smoke came out while doing the bench test.... Now none of the screw terminal outputs work and all the relays on the relay card are stuck in the on (green) state. Activating a relay output just makes the green led dim a bit.
The heartbeat/communications are still good and motors still move (connected thru the DB25) Question is can I purchase just an acorn board minus the BBG and use my BBG? or do I have to buy a whole new kit?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
dpascucci_support wrote: ↑Fri Mar 01, 2024 5:09 pm
The serial number for Acorn boards are the last 4 digits in the SystemID, found in the first F1-Setup page.
thats gonna be tough to do with a burnt up board....
the bar code is fine.. take a photo or type it out.
Now none of the screw terminal outputs work and all the relays on the relay card are stuck in the on (green) state. Activating a relay output just makes the green led dim a bit.