**RESOLVED** dc 1 communication
Moderator: cnckeith
-
johnscnc
- Posts: 5
- Joined: Wed Mar 31, 2010 1:27 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
**RESOLVED** dc 1 communication
hi, i might be blind but i cant find where it says how to hook the dc 1 to the dc3iob board. i noticed that the communication cable is not "staight through". is there a seperate manual for the dc1? if there is i did not recieve one.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Maint_1
- Posts: 83
- Joined: Sun Sep 19, 2010 3:24 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: A50391
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: dc 1 communication
Here you go.
- Attachments
-
- Ajax_DC3MAN.pdf
- (333.01 KiB) Downloaded 215 times
-
- Ajax_DC1_MAN.pdf
- (117.42 KiB) Downloaded 232 times
(Note: Liking will "up vote" a post in the search results helping others find good information faster)