Axis pairing

[Baddad1911]

Hello centroid community, I'm still attempting to bench my acorn have all axis moving except when I try to pair my x axis it only works the one time I actually configure it in the wizard. If I close cnc12 and then open the system back up I only get one motor to move and when I go back into the wizard its unpaired again ?? I'm very green and this is my first build , I've tried to get the report but am struggling with getting it to the forum ,any thoughts would be appreciated
Thanks Bill

[Gary Campbell]

Post pictures of your Wizard settings and a current report

[Baddad1911]

Ok gary, it took me a bit but here is two reports and a link to a you tube video
https://youtu.be/XBcLamW10VU

[cnckeith]

thanks.. gary was asking for screen shots of the wizards menus. use the Windows built in "Snipping Tool" just type in "SNIP" in the search bar and it pops up.

[cnckeith]

hello. the report shows you are using CNC12 Free. software axis motor pairing is not a standard feature of CNC12 Free. Upgrade to CNC12 Pro for software axis pairing or reinstall the Pro License file using the Utility menu.