KP-3 Probe
Moderator: cnckeith
-
Robs-shiz
- Posts: 25
- Joined: Sat Sep 12, 2020 11:18 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: 0617200971
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
KP-3 Probe
I just purchased the KP-3 probe and got it set up on my machine. When I go to set Z0 for my part the probe touches, retracts, then touches again, and stays on the part. Is this normal? I try to use tool check to retract the tool but it does not work and it states it is because the probe is tripped. However when I auto measure using the probe as the reference tool it seem to work fine. Any help would be appreciated. Thank You
- Attachments
-
- report_0008DC111213-0617200971_2025-09-14_15-09-10.zip
- (1.51 MiB) Not downloaded yet
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3834
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: KP-3 Probe
At the moment this is normal.
Retract with Z x1
The macro will be updated soon.
Uwe
Retract with Z x1
The macro will be updated soon.
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)