Homing switch position
Moderator: cnckeith
-
Terry1956
- Posts: 66
- Joined: Thu Jan 11, 2024 6:48 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Homing switch position
Hi, I am at the point of adding homing switches to my lathe. However do i position them in the X+ or X- position. Thanks
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3766
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: Homing switch position
+X for safety reasons.
Uwe
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Terry1956
- Posts: 66
- Joined: Thu Jan 11, 2024 6:48 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Homing switch position
Thanks
(Note: Liking will "up vote" a post in the search results helping others find good information faster)