New Centroid Touch Probe and Tool Touch Off hookup schematics for hickory are here.

[cnckeith]

New Centroid Touch Probe and Tool Touch Off hookup schematics for hickory are here.

https://www.centroidcnc.com/centroid_di ... term=15306

https://www.centroidcnc.com/centroid_di ... term=15307

[spumco]

Thanks for the schematics.

Note that the 'Inverting' cable sent with TT-4 (for Hickory) results in Hickory seeing an untriggered input as open, and a triggered input as closed.

So despite TT-4 being an (NC) component, it appears to Hickory as (NO).

Unfortunately, if 'TT-4" is selected in Hickory Wizard, then the input pin triggered state is pre-defined as "OPEN" and is not user-adjustable.

The only workaround I've found is to select "Mechanical Switch" type tool setter and set the input triggered state to CLOSED.

TT-4 connected/disconnected signal & logic work as expected.

I still don't understand why the non-inverting cable for Acorn/6 wont work with Hickory inputs... did not receive a reply to my last email asking this, so I wired it up according to the schematic and lied to the Wizard.

[centroid467]

Thanks for the schematics.

Note that the 'Inverting' cable sent with TT-4 (for Hickory) results in Hickory seeing an untriggered input as open, and a triggered input as closed.

So despite TT-4 being an (NC) component, it appears to Hickory as (NO).

Unfortunately, if 'TT-4" is selected in Hickory Wizard, then the input pin triggered state is pre-defined as "OPEN" and is not user-adjustable.

The only workaround I've found is to select "Mechanical Switch" type tool setter and set the input triggered state to CLOSED.

TT-4 connected/disconnected signal & logic work as expected.

This workaround is the correct way to set up a KP-3 or TT-4 with inverting cable when using a Hickory.

We are aware of the confusion this causes and updating the Hickory Wizard to match the supplied cables for Hickory probe/TT kits. This will be available in an upcoming release of the software.

[spumco]

This workaround is the correct way to set up a KP-3 or TT-4 with inverting cable when using a Hickory.

Thank you for the confirmation. First installation and I'm trying very hard to follow the 'official' instructions and not color outside the lines with wiring and configuration