Centroid Community CNC Support Forum

I studied the manual and found that I can swap the X and Y jog controls by changing bit 2 of parameter 1. I would basically enter a 4 into parameter 1.

I think I will just rewire my direction and pulse. I didn't want to at first because I will have to cut new wires since they won't reach for the ...

I have decided that it makes more sense to swap my X and Y axes. I have done so in the Wizard and the DRO reflects this change but the control panel has not changed - it still behaves as if the Y-Axis is as it was. Is there a way to make the control panel agree with the DRO axes? Currently after ...

Yes! It worked! Thank you! I remember Franko mentioning that the wizard was now inside the program but I couldn’t find it and the not matching the video is what threw me off. Thanks again!

Yes. it's a Dell and it's 1920x1200.

I have just installed CNC 12 Mill on a desktop that meets requirements and has been setup per the video. Everything everything went as it showed on the install/benchtest video except the wizard did not launch and cannot be found on the desktop or anywhere else. I then rebooted and still no wizard. I ...