Centroid Community CNC Support Forum

I tried jogging with the mouse and it did not pause. I also swapped monitors with the same model and it also paused with the different monitor. So it looks like a windows process issue. I dont see causing an issue for now, so we will see how it goess.

I also posted a vid of the dro and pid out while holding position.
The X axis seems a little bit dryer than y in regards to lube, but the Y axis is very wet. Z dripps from the spindle, but I will have to dig a little deeper to check that one. I know it doesn’t get warm after running for a while.

So just as a recap. If I jog the any axis with the vcp, it will move, then randomly pause, then continue on. All axis do this. Movement does not pause if a program is running. Video is in my photo album of x axis being jogged and problem presented.

Second issue is my servos are getting too hot ...

Please post a fresh report for us.
Also a wider shot video could help.
In the video you poster we're not able to see the machine or the entire screen.
Also, try jogging each axis from the center of the table; in the previous video it looks like you're at/past the limit of travel?

The report i ...

https://centroidcncforum.com/viewtopic.php?t=11866

Was hopeing for some follow-up to previous post linked above.
I posted a report . Zip in the original post and included a video on the photo album.
Secondly help with DC servo settings to prevent overheating of servo. Info is in my build thread ...

Any help here would be appreciated.

So just as a recap. If I jog the any axis with the vcp, it will move, then randomly pause, then continue on. All axis do this. Movement does not pause if a program is running. Video is in my photo album of x axis being jogged and problem presented.

Second issue is my servos are getting too hot. I ...

Actually i forgot, the link to the photo album is at the bottom of my post.

For some reason the website wont allow to add the video. Says it won’t take a .mov from my iPhone. However i will post a vid on my build thread with link to google photo. I have a recent report posted on my thread. From like a week ago and I haven’t done any changes to it. I’ll try and post another ...

Hello, I recently finished an all in one DC retrofit to my tree mill. I’ve noticed that when jogging and fast or slow every axis will pause, or hesitate from time to time -it does not seem consistent. Can anybody point me in the right direction as to what may cause this.