Centroid Community CNC Support Forum

I am thinking about purchasing the Lasertree K40 laser for our machine with an Acorn. It has a standard PWM input.
Has anyone had experience with this laser and setting it up on an Acorn?

I have another Lasertree on my mill.

You can use this schematic:

https://www.centroidcnc.com/dealersuppo ... 062.r2.pdf

I use Flood Cooling output for a valve to have air assist from my workshop compressor

Uwe

Thanks, did you do anything with the parameters at all or just setting the outputs in the Acorn Wizard?

I set only PWM Output and Laser enable like shown in the schematic.

PWM Setup in the Wizard

PWN Enable = Yes
Base Frequency = 1000
PWM S command range = 1000
Inverse Output = NO
Laser Cooling Fan delay timer = 10
I will confugure the PWM Output myself = Yes
the other ones = No

Uwe

Awesome, thanks.

suntravel wrote: ↑Wed Nov 15, 2023 10:29 am I have another Lasertree on my mill.

You can use this schematic:

https://www.centroidcnc.com/dealersuppo ... 062.r2.pdf

I use Flood Cooling output for a valve to have air assist from my workshop compressor

Uwe

Hello Uve

Having read you post on fitting a laser on your mill I bought the same laser from Amazon UK
Using the Centroid schematic shown in your link I have the laser 'firing up'.
I am now ready to move from "bench test" setup to finalise the project.

I cannot get the connection as shown in the NEJE schematic to switch the 24VDC on and off using the two relays as shown.

Do I need to assign output one a function?

Does your set up turn on and off +24v supply?

Hope this makes sense...

Thank you

Output 1 = NoFaultOut

Uwe

Thank you - did not see that in the literature or schematic.

I set this up tomorrow.

Output setup is in the upper left corner of the schematics: