Aux Contact output mapping to M Code
Posted: Mon Nov 06, 2023 5:24 pm
I am adding a function to my mill and would like to use the Aux9 output contactor, calling it up with an M Code in program (Both ON & OFF)?
Aux9 output is currently actuated by Aux3 Key.
This was used for a spindle brake pneumatic solenoid long before I acquired it (Don't need or use).
Not sure how to check and see if M Code function was set up?
Thanks
Aux9 output is currently actuated by Aux3 Key.
This was used for a spindle brake pneumatic solenoid long before I acquired it (Don't need or use).
Not sure how to check and see if M Code function was set up?
Thanks