Centroid Community CNC Support Forum

I HAVE TRIED USING THIS FORUM AND CANNOT GET A ANSWER FROM ANYONE EVER PERIOD AM I DOING SOMETHING WRONG? AM I POSTING IN WRONG PLACE OR DO I HAVE SOMETHING TURNED OFF BECAUSE I CANT GET HELP AT ALL.

People can see your posts. Just wanted to let you know that. I see that you posted 3 posts including this one. One has responses. The other is about a limit switch problem. I hate to tell you but the only resolution for something like that is to trace that all the way through to the controller. Something is tripping that input. In many cases, the CNC12 software has nothing to do with the real issue. Switches go bad, wires get pulled on, etc.

Guys
If you provide proper information of your problem with report, pictures and a short video clips then we are able to answer .
Also a short video clip of the problem is more helpful then the whole typed story .
Believe ma i am providing centroid services from last 20+ years in our region (Not USA) .without proper information i don't reply to customer

His first post back in August was answered within 55 Minutes by Tom B.

His second post was just a few hours before this one!!!

Perhaps he needs a new keyboard as the CapsLock appears to be stuck

what's the question?

I see you made on thread so far, and it has responses.

https://centroidcncforum.com/viewtopic. ... 710#p80710

and you also hijacked this thread.
https://centroidcncforum.com/viewtopic. ... 812#p78812

would be good for you to start a new thread on any new subjects and post good information as per the free tech support posting guidelines and you will get good help. this is the best CNC DIY forum on the internet with alot of smart people helping out!

if you don't want to do that an alternative is Centroid one on one tech support with a factory technician which is available for $120 / hr.
https://shopcentroidcnc.com/centroid-fa ... l-support/