Centroid Community CNC Support Forum

I have two CNC7 controls, one lathe and one mill.
Both keypads suffer from an annoying "key bounce", can this be adjusted?

Thanks

Do you have the serial numbers for those controls? Or if you can take a picture of them and post them here. Several different models of keypads have used over the years.

Bill,

The BIOS often has settings for "Typematic rate delay" that defines how fast a key repeats itself.

Liviu,
they are Tryax machines and the serial numbers are:-

M400 - 6570

T400- 2055

Scott,

The BIOS setting for "Typematic rate delay" was set fast so I have changed it to slow.

I will see what difference that makes next week and post back.

Thanks Bill.

Setting the "Typematic rate delay" to slow has improved the situation but I still have the problem.

Could it be the keyboard membrane and if so, what would be the cost of a new one ?

Thanks Bill.