Centroid Community CNC Support Forum

Hi to all

can some one help me and tell me that can i use laser tool setter?

http://www.blum-novotest.de/en/measurin ... tting.html

Does the aiax system(software and board) can detect diameter of tool to controller? or it can only measure length of tool?


Thank you

sml2011,

Unfortunately no you cannot use a laser tool setter. At this time the Centroid software is not setup for detecting and inputting tool diameter information into the tool offset library. You have to manually enter you tool diameter information.

We have the TT1 tool touch off available for purchase here: http://www.ajaxcnc.com/ajax-cnc-accessories/