Page 1 of 1
Got the DMM drives back
Posted: Tue Oct 23, 2018 11:08 am
by lilb93
Here is how they want them wired.
Re: Got the DMM drives back
Posted: Wed Oct 24, 2018 8:08 am
by martyscncgarage
So you got their DB25 cables this time correct?
If so, then yes wire them like they show.
Wire one on the bench, test it for motion
Report back after you have it moving.
There is a parameter you have to change in order for Acorn to detect DYN4's pulsing alarm output. Change 991 from 1000 to 1.
The next revision of software will do this automatically when DYN4 is selected.
Marty
Re: Got the DMM drives back
Posted: Wed Oct 24, 2018 8:26 am
by lilb93
Yes Marty I did get there Cables, waiting on three line reactors will be here Thursday. The Acorn expansion board will be here this morning.
Re: Got the DMM drives back
Posted: Wed Oct 24, 2018 8:57 am
by martyscncgarage
You mean Acorn relay board?
Sounds good take it one step at a time...
Re: Got the DMM drives back
Posted: Wed Oct 31, 2018 9:43 am
by Black Forest
Did you get this up and running yet?
Re: Got the DMM drives back
Posted: Wed Oct 31, 2018 9:13 pm
by lilb93
No there here sitting in the boxes they came in, Playing with my 7.5" trains.