Centroid Community CNC Support Forum

Introduction, been browsing the forum about a month and I plan on purchasing Acorn Board in the near future. Location Indiana. As I've come to discover most online retailers don't do an adequate job of identifying touch vs non-touch monitors/displays.

Nonetheless I've compiled a list of (touchscreen OR touch-screen) monitors/displays. Figured I'd be a good samaritan since it is the holiday season and pass it along to fellow enthusiasts. The list might be worthy of a becoming a sticky, I'll let the moderators be the judge.
If anyone finds this useful give me a shout, also if the Centroid Family wants to show me some love I won't complain !

I hope the list is at least beneficial to a few enthusiasts. Happy holidays and keep on plotting/plugging!


Spear

great!! thanks!

IS there a preferred screen resolution? I.E. 1920 x 1080 vs 1600 x 900? Sorry if I haven't seen this answer, I would like to go small as possible on my lathe build, but don't want to have to buy 2 monitors.

Asus VT168H 15.5" Touchscreen monitors work fine with CNC12. I have them on two machines.
https://www.asus.com/us/Monitors/VT168H/

Thanks Marty..
I was looking to go small, the 15 is even smaller than the 19's I was looking at. Better yet

Gary Campbell wrote: ↑Thu Nov 30, 2017 10:38 am IS there a preferred screen resolution? I.E. 1920 x 1080 vs 1600 x 900?

I was curious with regard to the same question, thanks for asking!

I was going to compile a 15-19" list, but first go around there were not enough options to justify a separate list, from memory it was only like 3-5 options currently available. I might go ahead and do a second scan for 9-19" touch screen monitors.

Once you go down to 7" you get into the rPi territory, and its hard to delineate between products.

Ryan