Page 1 of 1
Acorn lathe auto tool set up
Posted: Sun Jun 23, 2024 9:43 pm
by Clausing2020
Hello to all. My first question is. Is there any documentation on the use of the auto tool set up with a probe? I have the probe working but the X axis is coming out about .750 to the positive side. This is after I do the z and x probe. I could use a good explanation on this subject.
Thanks John
Re: Acorn lathe auto tool set up
Posted: Mon Jun 24, 2024 1:54 am
by suntravel
Read the manual 5.5 and 5.12
Uwe
Re: Acorn lathe auto tool set up
Posted: Mon Jun 24, 2024 11:09 am
by Clausing2020
Well guys I do not know Why but I had to set the X Stylus size to 0 and now it works for all the OD tools. ID to come
Re: Acorn lathe auto tool set up
Posted: Mon Jun 24, 2024 11:14 am
by suntravel
Rear or front mount ?
Uwe
Re: Acorn lathe auto tool set up
Posted: Mon Jun 24, 2024 12:20 pm
by Clausing2020
Rear Mount
Re: Acorn lathe auto tool set up
Posted: Mon Jun 24, 2024 12:39 pm
by suntravel
K, there is a bug in 5.1, but should be solved soon.
Uwe