Page 5 of 9
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 5:30 pm
by Skunk
I have a Toshiba VFS7-2037P
Wired as suggested in a recent post.
OUT1 is Green.
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 6:08 pm
by cncsnw
If you have FLB connected to INP10, but nothing connected to FLC, then you do not have a complete circuit. That would explain why INP10 is red, and why you get a spindle drive fault message. Install wire #946, from your 0VDC (COM) distribution terminals, to FLC.
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 6:24 pm
by Skunk
I have FLC connected to TB1/13A
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 7:13 pm
by cncsnw
On your Alt-i screen, is INP10 red or green?
Can you post a current Report?
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 7:22 pm
by Skunk
Green...will post a report soon.
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 7:30 pm
by Skunk
Current report
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 8:43 pm
by cncsnw
Hmm. INP10 is green, but you are getting "9028 SPINDLE FAULT!"
You probably need some professional help, either on-site or via TeamViewer.
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 9:27 pm
by Skunk
This error too...Power Fault?
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Tue Apr 04, 2023 10:38 pm
by tblough
That is not an error. It is showing you the drive bus number. Refer to section 2.4 in the AllIn1DC CNC Control Installation Manual.
Re: Acer e-Mill Anilam to AllIn1DC conversion build
Posted: Wed Apr 05, 2023 8:23 am
by Skunk
cncsnw wrote: ↑Tue Apr 04, 2023 8:43 pm
Hmm. INP10 is green, but you are getting "9028 SPINDLE FAULT!"
You probably need some professional help, either on-site or via TeamViewer.
How do I get this ball rolling?