Centroid Community CNC Support Forum

thankyou so much, It works

pulsenpal wrote: ↑Fri Mar 22, 2019 12:09 pm is there a print resource detailing changes in ver 4.14 vs 4.12?

thx

yes the release notes are on the download page.

Hi every one, Mr ckeith, I baught the lathe pro, and I sent the e-mail that I have received with the report file to diysales@centroidcnc.com but no response, there is some tips sir ?

Djaber,
hello.
what date did you send the report.zip?
what is your Acorn serial number?
what name is the order under, i can't find any order with Djaber as the name.

cnckeith wrote: ↑Tue Apr 02, 2019 5:58 pm Djaber,
hello.
what date did you send the report.zip?
what is your Acorn serial number?
what name is the order under, i can't find any order with Djaber as the name.

Thanks a lot Mr keith is works

Djaber Kharoubi wrote: ↑Tue Apr 02, 2019 3:37 pm Hi every one, Mr ckeith, I baught the lathe pro, and I sent the e-mail that I have received with the report file to diysales@centroidcnc.com but no response, there is some tips sir ?

What did you do to fix the problem? What was the problem?
Its good to bring these things to a closure so all that read what you ran into, who might have a similar problem would know what to look for.
Marty

i found his email and got the report and then sent the license file, he emailed back "all good" lathe pro is up and running on his system, the only issue is he didn't have a license file to install.

martyscncgarage wrote: ↑Wed Apr 03, 2019 9:56 am

Djaber Kharoubi wrote: ↑Tue Apr 02, 2019 3:37 pm Hi every one, Mr ckeith, I baught the lathe pro, and I sent the e-mail that I have received with the report file to diysales@centroidcnc.com but no response, there is some tips sir ?

What did you do to fix the problem? What was the problem?
Its good to bring these things to a closure so all that read what you ran into, who might have a similar problem would know what to look for.
Marty

cnckeith wrote: ↑Wed Apr 03, 2019 10:38 am i found his email and got the report and then sent the license file, he emailed back "all good" lathe pro is up and running on his system, the only issue is he didn't have a license file to install.

martyscncgarage wrote: ↑Wed Apr 03, 2019 9:56 am

Djaber Kharoubi wrote: ↑Tue Apr 02, 2019 3:37 pm Hi every one, Mr ckeith, I baught the lathe pro, and I sent the e-mail that I have received with the report file to diysales@centroidcnc.com but no response, there is some tips sir ?

What did you do to fix the problem? What was the problem?
Its good to bring these things to a closure so all that read what you ran into, who might have a similar problem would know what to look for.
Marty

Ah, roger that Keith.

the licence file is recived and it's done, thnk you sir

So what is the biggest reason to have this new version? I do not like the fact it won't do the inch/mm conversion, that is a step backwards in my opinion. Heck, it's been so long since I've used my CNC mill, I feel like I have to relearn everything anyhow.