Page 4 of 4
Re: Endurance Laser
Posted: Wed Apr 21, 2021 5:18 pm
by Rut24
I have tried this a number of times. It will turn the laser on but will not turn on the laser beam?
I have also tried a number of times to get the controller to control the %power of the laser but the only way to control the power is if I change the Base Frequency in Wizard.
It seems I am getting no control from the spindle relay. I do note that when I Enable the Laser and it calls for power that relay 1 and 8 are activated.
Re: Endurance Laser
Posted: Wed Apr 21, 2021 5:20 pm
by martyscncgarage
Rut24 wrote: ↑Wed Apr 21, 2021 5:18 pm
I have tried this a number of times. It will turn the laser on but will not turn on the laser beam?
I have also tried a number of times to get the controller to control the %power of the laser but the only way to control the power is if I change the Base Frequency in Wizard.
It seems I am getting no control from the spindle relay. I do note that when I Enable the Laser and it calls for power that relay 1 and 8 are activated.
Can you post a picture of your Acorn board and a FRESH report please?
I assume you got your new Acorn board?
Did you post all the information and specifications of the Endurance Laser?
Re: Endurance Laser
Posted: Wed Apr 21, 2021 5:39 pm
by martyscncgarage
Rut24 wrote: ↑Wed Apr 21, 2021 5:18 pm
I have tried this a number of times. It will turn the laser on but will not turn on the laser beam?
I have also tried a number of times to get the controller to control the %power of the laser but the only way to control the power is if I change the Base Frequency in Wizard.
It seems I am getting no control from the spindle relay. I do note that when I Enable the Laser and it calls for power that relay 1 and 8 are activated.
Any way you can test the laser itself to make sure it is operating without connecting it to Acorn?