Centroid Community CNC Support Forum

Posted: **Sun Jan 19, 2020 6:12 pm**

Toysrfun wrote: ↑Sat Jan 18, 2020 2:01 am Took the steppers off and used ac servos and it machines very nice and in fact it plows through aluminum dry better than my m400 bed mill. Thanks for the input even though nothing suggested/advised had helped.

Those are stepper drives in the photos???
As to the suggestions, you clearly didn't do most of them and report back.
Happy to see you're up and running but the problem was NOT what you believe it was.

Centroid Community CNC Support Forum

Stepper missing steps tried PLC968 not fixed

Re: Stepper missing steps tried PLC968 not fixed