Page 3 of 3
Re: HELP! - Big Mistake - ATC Proximity Sensor
Posted: Thu Sep 04, 2025 2:58 pm
by RJS100
Thanks... Really appreciate you bringing this to my attention!
Re: HELP! - Big Mistake - ATC Proximity Sensor
Posted: Thu Sep 04, 2025 3:18 pm
by RJS100
Looking at your drawing.... It looks like you used a one piece fork. Did you machine it from Delrin?
Re: HELP! - Big Mistake - ATC Proximity Sensor
Posted: Thu Sep 04, 2025 10:36 pm
by Greg
Yes single piece from delrin. They are kind of sacrificial in a way, much better to break off a fork then bend your platter or main shaft.
Re: HELP! - Big Mistake - ATC Proximity Sensor
Posted: Thu Sep 04, 2025 10:47 pm
by RJS100
My thoughts exactly... I machined some out of Delrin and 3d printed some as well to use during testing. The 3d printed ones will snap easily for sure.