Centroid Community CNC Support Forum

cnckeith wrote: ↑Thu Jul 07, 2022 12:56 pm post photo and or sketch of your wiring and link to laser manual

Keith,

I have tested the laser with the manufacturer and have found it to be satisfactory. (Endurance Lasers) I have posted you pictures of the connections as per your request.
You will note that the red wire goes to 12vdc, black wire goes to ground, yellow wire goes to pin 14, and blue wire goes to a common pin. These are the only connection on the laser control board.

review these.

https://www.centroidcnc.com/dealersuppo ... 062.r2.pdf

https://www.centroidcnc.com/dealersuppo ... 061.r2.pdf

double check you don't have things flipped around.

Are you seeing something that I have done wrong??