Centroid Community CNC Support Forum

It’s well documented in another thread but no acknowledgement by Centroid. That’s why I’m asking.

viewtopic.php?f=60&t=2193&start=20

It sure looks like I’m having the same problem. Not the point of this thread though. I have a thread about my random limit tripping.

Gary Campbell wrote: ↑Fri Feb 01, 2019 9:21 pm

slodat wrote: ↑Fri Feb 01, 2019 9:17 pm I was a software engineer in a former life. It appears a software issue is poking its head on my machine.

Did you report the issue? If both of the above are true, then you know how this works: You report it, we make it repeatable, they fix it!

Couldn't have said it better meeself Gary.