Are there any plans for centroid to support a standard Ethernet based fieldbus standard like Modbus TCP, Ethernet IP, or ethercat for spindle VFD control? It seems like this could provide a lot of advantage to users since these protocols are fairly common. Could allow for better communication with the drive, including drive status/error information.
Thanks!
Modbus TCP, ethercat, Ethernet/IP spindle control?
Moderator: cnckeith
-
carboncymbal
- Posts: 130
- Joined: Tue Dec 15, 2020 11:12 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8A1900-10082038
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Modbus TCP, ethercat, Ethernet/IP spindle control?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Gary Campbell
- Posts: 2306
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
Re: Modbus TCP, ethercat, Ethernet/IP spindle control?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
eng199
- Posts: 407
- Joined: Fri Jan 10, 2014 11:29 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Howard, PA
Re: Modbus TCP, ethercat, Ethernet/IP spindle control?
EtherCAT spindle VFD control is not currently supported, but will be at some point.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)