A year after moving into my new house, I've finally gotten around to getting my CNC machine up and running.
I'm trying to setup a new PC to run CNC12, and am having an issue where the VCP disappears a few seconds after launching. Any idea on how to fix this? I double checked I set all the PC/firewall settings correctly per the video guides. My new PC is running Windows 11.
VCP loads and then disappears
Moderator: cnckeith
-
maxmeaker
- Posts: 35
- Joined: Thu Oct 17, 2019 11:36 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734901A7-0627192197
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
VCP loads and then disappears
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
maxmeaker
- Posts: 35
- Joined: Thu Oct 17, 2019 11:36 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734901A7-0627192197
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: VCP loads and then disappears
Turns out launching CNC12 as an administrator solved my issue
(Note: Liking will "up vote" a post in the search results helping others find good information faster)