Cutting Undersized (Resolved)

cbb1962 · Post by **cbb1962** » Wed Dec 25, 2019 2:19 pm

I was working in my barn and found the part.

Mkelcy · Post by **Mkelcy** » Thu Dec 26, 2019 12:47 pm

I worked around my issue (called for "oversize" holes in VCarve), but still have no idea what caused the error.

Gary Campbell · Post by **Gary Campbell** » Thu Dec 26, 2019 1:23 pm

Have you cut a slow feedrate shallow slot and measured the width that the bit actually cuts in your material? You may be surprised, some solid carbide bits are undersized a bit.

If you cut the holes once climb and then again conventional do the hole sizes change?

Mkelcy · Post by **Mkelcy** » Thu Dec 26, 2019 10:46 pm

Gary - I'll try your suggested tests and report back.

Mkelcy · Post by **Mkelcy** » Mon Sep 21, 2020 1:11 am

Follow-up. I've been told by the internet that my problem is an issue in the VCarve pocket toolpath (and not the hardware) and was advised to use a profile toolpath. I did and it cut the exact size hole I wanted.

Post by **martyscncgarage** » Mon Sep 21, 2020 10:47 am

Mkelcy wrote: ↑Mon Sep 21, 2020 1:11 am Follow-up. I've been told by the internet that my problem is an issue in the VCarve pocket toolpath (and not the hardware) and was advised to use a profile toolpath. I did and it cut the exact size hole I wanted.

Wow, almost a year...thanks for the follow up!
Marty

Centroid Community CNC Support Forum

Cutting Undersized (Resolved)

Re: Cutting Undersized

Re: Cutting Undersized

Re: Cutting Undersized

Re: Cutting Undersized

Re: Cutting Undersized

Re: Cutting Undersized