CNC12 V5.08 Feedrate is controlled by rapidfeed control

[RC-Lights]

hi guys,

today i had a really strange mistake. i did some easy cuts for figure out how to produce better surface in a radius. ( see other thread later ).

attached you can find the g-code created 100% in Intercon without any manual modification.

i wondered, because the feed while turning was really slow. and also the time calculated was around 30sek, the real time needed was around 2minutes.

so i double checked the feed status and it was 100%. My rapid feed was on 25%, because new programm.

after checking the g-code i did the programm again and tried to adjust rapid feed. and voila, the turning feed changed with changing the rapid feed, but display on the monitor stayed 100%.

after restarting AcornSix everything works fine, so i cannot film it.

maybe you have an idea for the reason.

kind regards,
Michael

[suntravel]

Not sure if I remember right, but this should be fixed in current 5.1

Uwe