Ohmic false positive
-
- Posts: 6
- Joined: Thu Jul 01, 2021 11:35 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Ohmic false positive
Wondering if a pull resister is needed on input #9. Every so often the torch will intiate after safe height and before touch off is made on material. if so is a 10K appropriate?
-
- Posts: 528
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Ohmic false positive
So the Torch touch or ohmic will give a false touch off sometimes? Is this from material in the tip? or water?