Centroid Community CNC Support Forum

Hi everyone,
New here and trying to identify a control set up on a CNC lathe. It's a lathe came with a centroid control the hard drive has failed ( short circuit in memory chip and not recoverable . Trying to start rebuilding the software. But need to at least identify the components before opening a support ticket with centroid.
Could anyone help identify what control is on the machine as I am not familiar , or point me in the right direction . Any help greatly appreciated

Pics are here
https://photos.app.goo.gl/rrgivsaAm5XDzsGm9

Hello,
This T400 system is based on MPU11 and uses GPIO4D for the PLC and OpticDirect/YASINTF boards for drive interface. Please use the kit serial number (102095) when you get to the point of asking support about licenses and so on.

Brilliant thanks so much .