Entering MDI sets Parameter 64 to 0
Posted: Mon Dec 04, 2023 8:42 pm
Hello,
Finally getting my machine moving and encountered some strange behavior. Before homing, if you enter MDI mode, parameter 64 is being reset to 0. This decouples the paired X and B axes, which could be catastrophic if a move is made. Parameter 64 remains set correctly during restarts, but as soon as MDI mode is entered (with the machine un-homed) it appears to be reset to 0. Has anyone encountered this before? Thanks!
-Paul
Finally getting my machine moving and encountered some strange behavior. Before homing, if you enter MDI mode, parameter 64 is being reset to 0. This decouples the paired X and B axes, which could be catastrophic if a move is made. Parameter 64 remains set correctly during restarts, but as soon as MDI mode is entered (with the machine un-homed) it appears to be reset to 0. Has anyone encountered this before? Thanks!
-Paul