Hi everyone,
New here and trying to identify a control set up on a CNC lathe. It's a lathe came with a centroid control the hard drive has failed ( short circuit in memory chip and not recoverable . Trying to start rebuilding the software. But need to at least identify the components before opening a support ticket with centroid.
Could anyone help identify what control is on the machine as I am not familiar , or point me in the right direction . Any help greatly appreciated
Pics are here
https://photos.app.goo.gl/rrgivsaAm5XDzsGm9
Trying to identify controller
Moderator: cnckeith
-
- Posts: 6
- Joined: Thu Apr 04, 2024 8:47 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 102095
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
-
- Posts: 317
- Joined: Thu Apr 14, 2022 2:46 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Re: Trying to identify controller
Hello,
This T400 system is based on MPU11 and uses GPIO4D for the PLC and OpticDirect/YASINTF boards for drive interface. Please use the kit serial number (102095) when you get to the point of asking support about licenses and so on.
This T400 system is based on MPU11 and uses GPIO4D for the PLC and OpticDirect/YASINTF boards for drive interface. Please use the kit serial number (102095) when you get to the point of asking support about licenses and so on.
-
- Posts: 6
- Joined: Thu Apr 04, 2024 8:47 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 102095
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Trying to identify controller
Brilliant thanks so much .