My BP conversion has been working fairlt well.
However, today when I started the machine, after clicking the reset button I constintly am getting an "X axis positioning erro"
Can anyone help.
Thanks,
Alex
x axis positioning erro
Moderator: cnckeith
-
- Posts: 7
- Joined: Thu Apr 01, 2010 7:26 am
- Allin1DC CNC Controller: No
- CNC Control System Serial Number: can't access serial no. until
software is installed. Soon. - DC3IOB: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: seattle
Re: x axis positioning error
Sorry for the typos.
My BP conversion has been working fairly well.
However, today when I started the machine, after clicking the reset button I am constantly getting an "X axis positioning error"
Can anyone help.
Thanks,
Alex
Posts: 4
Joined: Thu Apr 01, 2010 7:26 am
Private message
My BP conversion has been working fairly well.
However, today when I started the machine, after clicking the reset button I am constantly getting an "X axis positioning error"
Can anyone help.
Thanks,
Alex
Posts: 4
Joined: Thu Apr 01, 2010 7:26 am
Private message
Re: x axis positioning erro
I would reboot the operation system and see if that corrects the problem being it worked fine before.
Re: x axis positioning erro
Do you hear your Estop contactor pulling in when you release Estop?
If so, do you have ~120VDC at VM+ & VM- on the DC3IOB?
Go into the diagnostics screen, are any of the limits or emergency lit?
If so, do you have ~120VDC at VM+ & VM- on the DC3IOB?
Go into the diagnostics screen, are any of the limits or emergency lit?