SOLD!!! Servo for Lathe C axis use
Posted: Wed May 31, 2023 1:06 pm
SOLD
I have for sale the following items that are new and in the box. This is a motor/drive combo that is capable of both ~3000 RPM (via -10/+10 control) AND Step and direction positioning. Swap between the two is handled by a single input. Drive is 230V single phase
LeadShine ELM1000LH80F-SS 1kw Servo Motor
LeadShine ELP-RS1000Z Servo Drive
LeadShine Encoder Cable 1.5 meter
LeadShine Power Cable 1.5 meter
LeadShine "Test & Tune" cable
CNC4PC C89 R1 Interface Board This interface board converts Acorns 0-10v RPM signal and the FWD & REV signals into -10v - 0v - +10v control voltage for the servo drive in velocity mode.
Digital manuals for each component are included on thumb drive with the products. These were purchased for a lathe/indexer project that never came to fruition. ~$600 invested asking $400 OBO
Email: gcnc411@gmail.com to purchase or for more information
I have for sale the following items that are new and in the box. This is a motor/drive combo that is capable of both ~3000 RPM (via -10/+10 control) AND Step and direction positioning. Swap between the two is handled by a single input. Drive is 230V single phase
LeadShine ELM1000LH80F-SS 1kw Servo Motor
LeadShine ELP-RS1000Z Servo Drive
LeadShine Encoder Cable 1.5 meter
LeadShine Power Cable 1.5 meter
LeadShine "Test & Tune" cable
CNC4PC C89 R1 Interface Board This interface board converts Acorns 0-10v RPM signal and the FWD & REV signals into -10v - 0v - +10v control voltage for the servo drive in velocity mode.
Digital manuals for each component are included on thumb drive with the products. These were purchased for a lathe/indexer project that never came to fruition. ~$600 invested asking $400 OBO
Email: gcnc411@gmail.com to purchase or for more information