Nice workaround, but the problem that #25102 is always -1 is not solved.
On my lathe #25108 is working fine with the Index from the spindle encoder.
Since you also have a working encoder now, can you test if #25108 is set to a value other than -1 after one turn of the spindle?
Uwe
AcornSix - Zri Homing with linear scales
Moderator: cnckeith
-
- Posts: 46
- Joined: Sat Jan 21, 2023 6:20 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0008DC111213-1005220061
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: AcornSix - Zri Homing with linear scales
Hi Uwe, good Point. I checked it and 25108 is working as supposed, all other axis are always -1.
-
- Posts: 2092
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: AcornSix - Zri Homing with linear scales
In this case it looks like Acorn6 is handling the encoder input if a scale is setup for an axis differently opposed to a rotary encoder for the spindle.
It would be nice if someone from Centroid could check this out.
Uwe
It would be nice if someone from Centroid could check this out.
Uwe