New Build LMS 3990 Hi Torque Mini Mill

[cdiseker]

Suntravel, Thanks so much! I'm out to the shop this morning to setup the tool library, etc. in CNC12 then doing a test run.

[cdiseker]

I need to repeat a tool path drilling some holes. Seems my too offset was off and the drill bit did no go down far enough. How can I start from tool 4 in this case?

[tblough]

F4 Run, F2 search

[cdiseker]

Thanks.

[cdiseker]

Is it possible to delete a current job in CNC12?
As I update my model in Fusion360 and run it again I'd rather not have multiple file names for the same job but edit in Fusion and save it as current.

[suntravel]

If the new job with same name is placed in the same location as the current job, CNC12 will execute the new job.

Uwe

[cdiseker]

So, just load the new job file and Cycle Start?

[suntravel]

If 1111.nc is loaded and you replace this file with a new version 1111.nc just hit cycle start.

No need to load it again.

Uwe

[cdiseker]

Okay, thanks.