Snubber, flyback resistor, surge unit??
Moderator: cnckeith
-
garybergin288
- Posts: 33
- Joined: Thu Jun 01, 2023 1:22 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Snubber, flyback resistor, surge unit??
from my reqding of other forum posts its recommended that a snubber be used on on AC coils and a resistor be used for DC coils. My contactor im using has a 24VDC coil, the manufacturer sells an accessory called a surge unit(varistor) is this basically the same thing? and will it acheive the desired effect? i have attached the technical doc thanks
-
eng199
- Posts: 390
- Joined: Fri Jan 10, 2014 11:29 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Howard, PA
Re: Snubber, flyback resistor, surge unit??
Yes, that is the right thing. Looks like it was designed to have the desired effect.