Wantai Drives

Maker1970 · Post by **Maker1970** » Thu Apr 04, 2019 11:05 am

Anyone have any help with my bench test. My DRO's are working but no luck with turning the motor. I can't seem to find a schematic that covers my drive. It's a Wantai DQ542MA hooked up to an open loop stepper. It ran on just step and direction wired to the previous BOB. Any help would be appreciated. Pretty sure that I have everything in the wizard correct.

: Drive pic

Maker1970 · Post by **Maker1970** » Thu Apr 04, 2019 1:12 pm

Got it. litterally as many ways to wire these drives as the are boards to hook them up to. 5v dc to enable+, puls+ and dir+. lots of jumpers.

Dan M · Post by **Dan M** » Thu Apr 04, 2019 1:20 pm

Did you look at wiring it to the DB25? Don't quote me on it but I don't think you need jumpers. I'm pretty sure the DB25 supplies the 5v. I have different drivers so mine are wired different, but those look like leadshines so you should look at the leadshine wiring diagrams. Just try and find out what leadshine drive those are a copy of and use that diagram to wire them.

I'm sure if Gary sees this post he can point you in the right direction since he uses leadshine drivers.

Maker1970 · Post by **Maker1970** » Thu Apr 04, 2019 2:12 pm

That's how I got there. Well that and a a loot of pictures on google....

Maker1970 · Post by **Maker1970** » Thu Apr 04, 2019 2:16 pm

I'm really excited to give this new system a rip. I've been struggling with Mach 3 for over 2 years now. It's just not a stable platform at all.

Post by **cnckeith** » Thu Apr 04, 2019 3:02 pm

report.zip and screen shots of the wizard menus and we can comment. are you using the screw terminals or db25?
viewtopic.php?f=20&t=383

Gary Campbell · Post by **Gary Campbell** » Thu Apr 04, 2019 3:14 pm

Connect using this schematic

S14901-ACORN_rev3_LEADSHINE_DM_856,870,1182_&_2282.pdf: (84.85 KiB) Downloaded 119 times

Maker1970 · Post by **Maker1970** » Thu Apr 04, 2019 4:50 pm

yep, it hot now. Was just like the leadshine, only I have +5v on enable also. Working on limits now. Should be back up and running soon. Just have to figure out the touch off system and tune and ,and and...LOL

Maker1970 · Post by **Maker1970** » Thu Apr 04, 2019 4:54 pm

It's screw terminals btw

Maker1970 · Post by **Maker1970** » Thu Apr 04, 2019 6:21 pm

So here is one for you guys. Trying to home and Y wants to home to the +. I did have to reverse the direction on that axis. Should I have switched a wire instead, or would that equate to the same thing? Or is there a setting to change what direction it home to?

Centroid Community CNC Support Forum

Wantai Drives

Wantai Drives

Re: Wantai Drives

Re: Wantai Drives

Re: Wantai Drives

Re: Wantai Drives

Re: Wantai Drives

Re: Wantai Drives

Re: Wantai Drives

Re: Wantai Drives

Re: Wantai Drives