Centroid Community CNC Support Forum

Speeding the Z up more should also help. 200ipm max rate could be better. Max the Z out and find its limit.

I'll look into THC turning off when in restart. Restart should reset all settings back to how they were set when entering restart mode.

For reliable THC operation always run a job with Feed Rate over ride set to 100%. I would set set the Cut height slightly higher to give the Z more time to react if possible. Or dial back the Feedrate. Try to cut at the slowest Feedrate and amperage as possible to get the Z more time to react. Tune ...

What is the X and Y and Z Accel decell settings?

Can you attach a picture of the Wizards Configuration menu please

Try a higher cut height to give the Z axis more time to react.

Do you have a THC plot capture of the Cut in the Video?

If so please attach a snip picture of the plot.

Your making progress. The purple is the THC anti dive. This is controlled by the Anti Dive Hysteresis in the THC config. If the voltage rises more than 7 percent of the target voltage then anti dive will kick in. Default settings is 7 percent o believe I would increase the anti dive from the stock 7...

Torch Calibration is in the "Utils" button on the bottom of the VCP.

Yes

When installing CNC12 you will see an option for a Router/ Plasma combination.

The installer will download both Router and Plasma versions with a Desktop swap button for jumping from the plasma to router software.

There is a video link in my Post found here https://centroidcncforum.com/viewtopic. ... eed#p67483

Thanks for pointing this out Guys, Pg.3 and 9 of the Plasma Manual has been updated.

You can find the Updated manual here
https://www.centroidcnc.com/centroid_di ... manual.pdf

The AIKRON Model:AKM1 Has been Tested at Centroid. The Signal Type Needs to be the 5v RS422 https://www.aikrondro.com/product/aikron-akm-series-linear-encoders/ I've attached a snip of the DB9 connector of the Aikron and the Changes needed to match the Centroid DB9 Encoder Port. Aikron Scale Wiring....

Acorn Plasma Takes care of any ''Tool'' settings. Acorn Plasma comes with all default Profiles from Hypertherm.
Acorn Plasma does not use any of the tool information from Sheetcam .

Sheetcam Has a forum if you really want the Sheetcam toolset.