Centroid Community CNC Support Forum

All,

I have had to upgrade my system from 4.5 to 5.10. This was because I had an xml error in microsoft. That aside, after the upgrade and redoing all of my settings from photos, I finally got it working, all except this spindle fault. When the spindle is activated, whether using the spindle start ...

The twisted pair idea worked well. Also make sure u ground your shielding.

I certainly like my WEG Electric CFW300. It has fantastic programming usb port, if you are into that kinda thing. Super easy to setup. I purchased it thru automation direct.

I will move the vfd and all that apply out of the cabinet tomorrow. I guess what still throws me into a state of confusion is why does one servo work, granted it has the shortest run, and the others don't? Does the length of the controller wires make that big of a difference? Should the 10k ohm ...

I am working on the same conversion and I have the same problem. When I bench tested the unit, all worked fine, I had all of my wiring done so all that I had to do was pull the step and direction wires thru the case and boom, it should have worked. I did use longer wires to connect my Y and Z. My X ...