Regarding resend errors someone on this forum pointed out recently that starting the PC before powering up the Acorn bord helps. It certainly helped in my case to get rid of the MPU/resend errors.
Cheers, James
Search found 4 matches
- Thu Jul 15, 2021 9:12 am
- Forum: Centroid Acorn CNC Controller
- Topic: Jog button in VCP sticks on
- Replies: 95
- Views: 44675
Re: Jog button in VCP sticks on
This post has been liked 0 time(s).
- Fri Jun 19, 2020 10:51 am
- Forum: Centroid Acorn CNC Controller
- Topic: Acorn Rev 3 vs. Rev 4
- Replies: 6
- Views: 3052
Re: Acorn Rev 3 vs. Rev 4
Thanks Marty. I put in an order this morning direct with centroid this morning. I just need to pull my finger out and get on with finishing the bearing blocks and motor mounts 
This post has been liked 0 time(s).
- Thu Jun 18, 2020 2:04 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Acorn Rev 3 vs. Rev 4
- Replies: 6
- Views: 3052
Re: Acorn Rev 3 vs. Rev 4
Thank you for the super fast response and link to an alternative European supplier . I'll try and find out if its the newer board they are selling
. I'll try and find out if its the newer board they are sellingThis post has been liked 0 time(s).
- Thu Jun 18, 2020 1:38 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Acorn Rev 3 vs. Rev 4
- Replies: 6
- Views: 3052
Acorn Rev 3 vs. Rev 4
Hi there. I am right at the start of my CNC journey, converting an SX2.7L mill here in the UK. I am trying to source an Acorn board from RGB Automatyca in Poland, but they seem to only have the Rev 3 board, and not Rev 4. Is this likley to be a problem for me? Or should I search harder for a Rev 4 ...
This post has been liked 0 time(s).