The rapid is needed. For best results, position the cutter just clear of the part, at cut depth, before turning cutter compensation on. Make your cut around the part. Then turn cutter compensation off and lead out clear of the part. Do not attempt to leave cutter compensation active as you jump from...
For better or worse, that is the intended behavior of the one-shot canned cycles: they retain the values you last used, in the expectation that the next time you use it, you will probably be doing the same feature, or something similar. You should be able to show or hide the help graphics by pressin...
Nice work. You might want to rearrange your cable routing, to keep the servo motor power cables better separated from your input and signal cables and wiring. The servo motor power cabling can be a significant source of noise. Buy two finger guards (FG4) for the transformer. Everything else in your ...
There is no need to assign VFDEnable_O to an output. You would not do so if you choose to use SpinFWD and/or SpinREV instead. SpindleEnableOut_M is a memory bit (MEM168), which is always in place. I would open up PLC Detective (Ctrl-E from the CNC12 main screen), scroll down to around line #3745, an...
Homing Y positive is the default, because that is preferable on most milling machines. You do not have to use the default. You can set your homing directions to whatever you want. The direction any given axis homes (and the order in which the axes home) is determined by the instructions in the cncm....
Yes, it is okay to do that. I am fairly certain that, with power released, the Allin1DC essentially disconnects the motor, so there is no energy to absorb. But, even if it were in a dynamic braking mode (and you would know that when you tried to turn the cranks) the drive should still be able to dis...
From your one_shot_turn.xml button file: <vcp_button> <skin_event_num>20</skin_event_num> </vcp_button> From your one_shot_lathe_drill.xml button file: <vcp_button> <skin_event_num>68</skin_event_num> </vcp_button> From your one_shot_lathe_facing.xml button file: <vcp_button> <skin_event_num>24</ski...
The "G Code Tutor" reference applies to some controls in some configurations, but it is not universal, and in this detail it does not apply to Centroid. When you get into the finer details of canned cycles, there is a lot of variation between control manufacturers, and even between differe...