Centroid Community CNC Support Forum

I have not been able to resolve my final test problem. Attached please find a before and after screen shot, the test is started with the machine being homed and home being set in all three axis. Then all three axis were centered in there travel. FYI- I am going to use only the X Y Z of the system, I ...

Thank You,
I now have the machine homing as it should X is moving to the left homing out on X+ switch & arrow buttons are working correctly for X.
I also have Y homing out moving away from the column towards the operator on the Y+ switch, but the Y arrows on the keyboard are backwards.

I have run ...

Thank You for your response,

I have reconfigured X & Y servos- not completely sure/ seems as though it is backwards to other cnc vertical mills.
I now have the X homing out on the X- limit switch- moving to the left hand direction as the picture shows when homing.
X movement is now backwards to ...

Having problem with final set up & test program
Every thing seems to be homing out correctly-but the jog button for Y is backwards in motion when jogging.
When I first started up machine a program named testcnc was in job name line at the top of screen, but it did not seem to have a program attached ...

8-19 screen.doc
No change after unplugging MPU11 & restarting CNC11 program. DC3IOB board starts show small LED light by fiber1 socket lights up briefly- kicks off showing fault -toggling e-stop the light or board never restarts. Attach please find screen when doing so. Normal start up in my set ...

Thanks for the advice -Tried multiple starts no luck - to get it to restart I must power down both boards before it will try restart the DC3I/O board.
When I toggle the e-stop it shows e-stop detected then e-stop released then the fiber1 fault shows up again.
I looked at the fuses but can not see ...

Thanks for the response.
You asked--(What is the display on the 7-segment LED (LED1) on the DC3IOB unit?)
If I understand what you are asking, the LED number showing is 1.
Attached is real time I/O display if that may help you. screen with fault.doc
When powering up the Small LED light next to the ...

I am having difficulty in my bench top set up.
I have tried to follow the setup guide - I have reloaded the software a couple of times & also tried it on a different computer.
I do not have a MPG so using the forum directions I believe I have it disabled correctly.
The four LED lights on the MPU ...