Centroid Community CNC Support Forum

I checked and verified it's in the right plug, and that it's oriented correctly. It's fairly obvious, since somewhere along the way someone used hot glue on the edge of the connectors to make sure they didn't vibrate out. It's still on both halves. I talked to the operator, and got some additional i...

I carefully rechecked the cable. I checked pin to pin for continuity, pin to other pins for shorts, flexed cable during checks to see if there was a break, examined connectors for tightness. All looks OK. I was hoping to find something, because that's an easy fix!

dpascucci_support- I checked the cable with a voltmeter and saw continuity on all the lines. I also checked for shorts between the lines. I'll go back and recheck it tomorrow, but I think it's ok. cncsnw- Thanks for clarifying about the messages being normal. I suspected they were, but I could not c...

yes, switching from INC to CONT works.

I'm having some trouble using the pop-up keyboard (Alt-J) on my Centroid. I need to use it as I'm having trouble with the M400S membrane keyboard (jog panel), which is the subject of another post. Everything works on the pop-up except Continuous Jogging. The Incremental Jogging works fine. When I op...

My membrane keyboard on my M400S quit working. I've tried several things to get it working again without any success: - Replaced with new membrane keyboard ($650 - ouch) - Pulled daughter board from motherboard, cleaned connectors on daughter board and right angle adapter with scotchbrite. Examined ...