Centroid Community CNC Support Forum

I set parameter 4 to 24 that kind of fixed it. The narrative to Overwrite, Rename and Cancel doesn't show up but the filename shows up as being the correct one at the beginning of the gcode.

Where does one find a post processor after installation of a rotary?

To all who replied. Thank You
Back in business.

cnckeith, should I have seen those request?

The file system on my system will not accept a gcode file with the same name. Normally if try load a gcode file with the same name the system will let you know by squacking "the file already exist on C drive, overwrite, rename or cancel". This doesn't function anymore and I don't know why and it's ...

Thanks again, I appreciate it.

One more question, what is inverse time mode. Tried to look it up but no luck.

Thanks for the info

Vectric Aspire 12

Thanks, That what I was thinking but not sure.