Centroid Community CNC Support Forum

I did not make any changes to the Fulling parameters. Originally, I thought that I would need to, but once I got it wired up properly (see beginning of thread) I just ran the spindle bench test wizard and it was good. On a side note, I'll add that the signal wires coming from the VFD are crossing a ...

Thanks Centroid467! So far, so good. I hooked up S1(Spin Fwd) and GND (Common/Return) wires to the OUT4 relay , and the AVI and ACM wires to H8 on the Acorn. I added a wire from S4 on the VFD to the Out6 relay on Acorn, a wire from the VFD C terminal to IN5 on Acorn and finally, a wire from VFD B ...

Good morning all,
I am a novice CNC router owner, in the process of switching over to an Acorn control board from an old WIX HC USB control board that originally came with the CNC router. I'm looking for a little assistance in wiring up the VFD here.

Photos of the Machine and components in the ...

I have the software downloaded and PC configured. And I'm stuck. I couldn't find a wiring schematic for this old motion card. I was hoping that the labeling on the wires would just magically line up exactly with what is on the Acorn so that I could just unplug from the old one and plug into the new ...

Hello,
1st post on here. I purchased a machine from overseas a couple of years ago for some pool cue building. 100% of my experience has been through experimentation on this machine over the past couple of years. Recently, the machine has been erratic or not working at all. For example, I’ll run a ...