Centroid Community CNC Support Forum

Ok thanks

I have Acorn running pro license on my Lathe.
Can I down load CNC12 to a PC not connected to a Acorn board and use it like a off line CAM software.
It would be nice to work on parts at my deck and transfer the code to my lathe with a USB drive.

cnckeith wrote: ↑Wed Sep 25, 2019 1:42 pm please post the intercon file: .lth and a fresh report.zip and we can use your settings on our lathe.

I put 240= -1 I have good threads. 800 RPM just a touch of bump. I need to get this job out, I may go back and adjust the setting to see if i can get rid of the bump and get good threads later. If you have some min setting to start with a can work from to get a good thread with no bump post them ple...

That is the settings and this is the thread

The .02 has improved it but not 100% should I make the number smaller?

I read the threat posted and I set parameter 242 to 60. It fixed this issue of the OP of the posted thread but I am getting that same results.
I printed page 239 of the lathe manual and read about parameter 240-242. Any suggestions?

Thanks

How do I delete things I have put in the MDI line.