Centroid Community CNC Support Forum

An issue we are having is setting up the speeds for the three available in the gear box. The gearbox changes are manual, with two levers pushed on the front of the machine that trigger that trigger switches. I believe that that the switches are wired into the Oak board correctly, the three green ...

Wow thanks, that worked! It took a little guessing to find the right directory but there it was in front of us. I still have a few minor mechanical things to finalize like the sticky over travel switch and some wire ties in the electrical cabinet and I will be ready to make some chips!

Sorry if this is a duplicate, having trouble with my photos, sometimes they don't drag and drop first time

This is the schematic

Model AC Drive, FRN0069E2S-2GB
I think this is the link:
http://www.wolfautomation.com/media/pdf ... man-21.pdf

photos of the inverter connections

Fuji inverter high voltage

Centroid Support

Dear Support,

I purchased an Oak ( ID 1028190864) control from you in 2020 and have almost completed my installation. A combination of factors including COVID have prolonged this effort unfortunately and I am hoping to get it done now so that I can put the machine into service ...

I have installed an Oak board on a CNC lathe. Everything works correctly, except the X-axis jog buttons (i.e. the cutting tool) are reversed. The X encoder readout is spatially correct, and MDI commands to the X axis move in the correct direction, but the jog buttons are backwards. I am already ...

jj80909, wow, thank you, that helps a lot. Some times you need bad news to move forward. maybe a dumb question, but I see the 08AP servo packs used on ebay for cheap, will they drive my servos? Or are they matched to the controller? If I don't need to get new servos, that would make things easier.